3D Printer StepStick DRV8825 Stepper Motor Driver Reprap 4 PCB Board
˂
˃
3D Printer StepStick DRV8825 Stepper Motor Driver Reprap 4 PCB Board
Price:
₦5,300
Brand: Generic
Share:
Product Description
Simple steps and direction control interface
Thermal shutdown over temperature, overcurrent shutdown, undervoltage lockout
Short-circuit short-circuit load protection
Bare the ground pad on the bottom of the printed circuit board below the solder IC
Adjustable current control allows you to set a potentiometer that allows you to use the stepper motor at rated voltage above the voltage to achieve higher stepping rate output maximum current
Intelligent chopping control can automatically select the correct current decay mode (attenuation fast or slow decay)
Maximum 45 V supply voltage
Built-in voltage regulator (requires any external logic supply voltage)
size:1.5mmX2mm
Material:PCB
colour:Purple
Package Contents:
1 x Stepper Motor Driver
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
Thermal shutdown over temperature, overcurrent shutdown, undervoltage lockout
Short-circuit short-circuit load protection
Bare the ground pad on the bottom of the printed circuit board below the solder IC
Adjustable current control allows you to set a potentiometer that allows you to use the stepper motor at rated voltage above the voltage to achieve higher stepping rate output maximum current
Intelligent chopping control can automatically select the correct current decay mode (attenuation fast or slow decay)
Maximum 45 V supply voltage
Built-in voltage regulator (requires any external logic supply voltage)
size:1.5mmX2mm
Material:PCB
colour:Purple
Package Contents:
1 x Stepper Motor Driver
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
Product Specification
| Weight (kg) | 0.01 |
|---|